A galvanometer having a coil of resistance $30 \Omega$ need 20 mA of current for full-scale deflection. If a maximum current of 3 A is to be measured using this galvanometer, the resistance of the shunt to be added to the galvanometer should be $\frac{30}{X} \Omega$, where $X$ is

Consider a moving coil galvanomenter (MCG):

A. The torsional constant in moving coil galvanometer has dimentions $\left[\mathrm{ML}^2 \mathrm{~T}^{-2}\right]$

B. Increasing the current sensitivity may not necessarily increase the voltage sensitivity.

C. If we increase number of turns $(\mathrm{N})$ to its double $(2 \mathrm{~N})$, then the voltage sensitivity doubles.

D. MCG can be converted into an ammeter by introducing a shunt resistance of large value in parallel with galvanometer.

E. Current sensitivity of MCG depends inversely on number of turns of coil.

Choose the correct answer from the options given below:

Given below are two statements :

Statement-I : The equivalent emf of two nonideal batteries connected in parallel is smaller than either of the two emfs.

Statement-II : The equivalent internal resistance of two nonideal batteries connected in parallel is smaller than the internal resistance of either of the two batteries.

In the light of the above statements, choose the correct answer from the options given below.

Which of the following resistivity ( $\rho$ ) $\mathrm{v} / \mathrm{s}$ temperature ( T ) curves is most suitable to be used in wire bound standard resistors?