1
GATE ECE 1999
MCQ (Single Correct Answer)
+2
-0.6
The value of R (in ohms) required for maximum power transfer in the network shown in Fig. is
2
GATE ECE 1995
MCQ (More than One Correct Answer)
+2
-0
A DC circuit shown in the figure has a voltage source V, a current source I and several resistors. A particular resistor R dissipates a power of 4 Watts when V alone is active. The same resistor R dissipates a power of 9 Watts when I alone is active. The power dissipated by R when both sources are active will be

3
GATE ECE 1993
Numerical
+2
-0
In the circuit of figure, when switch S1
is closed, the ideal ammeter M1
reads 5A.
What will be ideal voltmeter M2
read when S1
is kept open? (The value of E is not
specified).


Your input ____
4
GATE ECE 1989
MCQ (Single Correct Answer)
+2
-0.6
A load, ZL = RL + jXL is to be matched, using an ideal transformer, to a generator of internal impedance, ZS = RS + jXS. The turns ratio of the transformer required is
GATE ECE Subjects
Browse all chapters by subject
Network Theory
Control Systems
Electronic Devices and VLSI
Analog Circuits
Digital Circuits
Microprocessors
Signals and Systems
Representation of Continuous Time Signal Fourier Series Fourier Transform Continuous Time Signal Laplace Transform Discrete Time Signal Fourier Series Fourier Transform Discrete Fourier Transform and Fast Fourier Transform Discrete Time Signal Z Transform Continuous Time Linear Invariant System Discrete Time Linear Time Invariant Systems Transmission of Signal Through Continuous Time LTI Systems Sampling Transmission of Signal Through Discrete Time Lti Systems Miscellaneous
Communications
Electromagnetics
General Aptitude