1
GATE ECE 2002
Subjective
+5
-0
Consider a parallel plate waveguide with plate separation d as shown in Fig. The electric and magnetic fields for the TEM mode are given by $${E_x} = \,{E_0}\,\,{e^{ - j\,k\,z + j\,\omega \,t}},\,{H_y} = {{{E_0}} \over \eta }\,{e^{ - j\,k\,z + j\,\omega \,t}}$$

Where $$k = \,\,\eta \,\omega \,\, \in $$
(a) Determine the surface charge densities $${\rho _s}$$ on the plates at x = 0 and x = d
(b) Determine the surface current densities $$\mathop {{J_s}}\limits^ \to $$ on the same plates.
(c) Prove that $${\rho _s}$$ and $$\mathop {{J_s}}\limits^ \to $$ satisfy the current continuity condition.

GATE ECE 2002 Electromagnetics - Waveguides Question 2 English
2
GATE ECE 2001
Subjective
+5
-0
A rectangular hollow metal waveguide has dimensions a = 2.29 cm and b = 1.02 cm. Microwave power at 10 GHz is transmitted through the waveguide in the $$T{E_{10}}$$ mode.
(a) Calculate the cut-off wavelength and the guide wavelength for this mode.
(b) What are the other (TE or TM) modes that can propagate through the waveguide?
(c) If a = b = 2.29 cm, what are the modes which can propagate through the waveguide?
3
GATE ECE 1999
Subjective
+5
-0
A 100 m section of an air-filled rectangular wave-guide operating in the $$T{E_{10}}$$ mode has a cross-sectional dimension of 1.071 cm $$ \times $$ 0.5 cm. Two pulses carriers of 21 GHz and 28 GHz are simultaneously launched at one end of the wave-guide section. What is the time delay difference between the two pulses at the other end of the waveguide?
4
GATE ECE 1998
Subjective
+5
-0
A rectangular waveguide with inner dimensions 6 cm $$ \times $$ 3 cm has been designed for a single mode operation. Find the possible frequency range of operation such that the lowest frequency is 5% above the cut off and the highest frequency is 5% below the cut off of the next higher mode.
GATE ECE Subjects
EXAM MAP
Medical
NEET
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
CBSE
Class 12