1
GATE ECE 2015 Set 1
Numerical
+2
-0
In the system shown in Figure (a), m(t) is a low-pass signal with bandwidth W Hz. The frequency response of the band-pass filter H(f) is shown in Figure (b). If it is desired that the output signal z(t) = 10x(t), the maximum value of W (in Hz) should be strictly less than ___________________________


Your input ____
2
GATE ECE 2007
MCQ (Single Correct Answer)
+2
-0.6
The 3 - dB bandwidth of the low - pass signal $${e^{ - 1}}$$ u(t), where u(t) is the unit step function, is given by
3
GATE ECE 2004
MCQ (Single Correct Answer)
+2
-0.6
A system has poles at 0.01 Hz, 1 Hz and 80 Hz; zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
4
GATE ECE 2004
MCQ (Single Correct Answer)
+2
-0.6
Consider the signal x(t) shown in Fig. Let h(t) denote the impulse response of the filter matched to x(t), with h(t) being non-zero only in the interval 0 to 4 sec. The slope of h(t) in the interval 3 < t < 4 sec is


Questions Asked from Transmission of Signal Through Continuous Time LTI Systems (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE ECE Subjects
Network Theory
Control Systems
Electronic Devices and VLSI
Analog Circuits
Digital Circuits
Microprocessors
Signals and Systems
Representation of Continuous Time Signal Fourier Series
Discrete Time Signal Fourier Series Fourier Transform
Discrete Time Signal Z Transform
Continuous Time Linear Invariant System
Transmission of Signal Through Continuous Time LTI Systems
Discrete Time Linear Time Invariant Systems
Sampling
Continuous Time Signal Laplace Transform
Discrete Fourier Transform and Fast Fourier Transform
Transmission of Signal Through Discrete Time Lti Systems
Miscellaneous
Fourier Transform
Communications
Electromagnetics
General Aptitude