1
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+2
-0.6
A two bus power system shown in figure supplies load of $$1.0+j0.5$$ $$p.u$$
The value of $${V_1}$$ in $$p.u$$ and $${\delta _2}$$ respectively are
2
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+2
-0.6
A distribution feeder of $$1$$ $$km$$ length having resistance, but negligible reactance, is fed from both the ends by $$400$$ $$V,$$ $$50$$ $$Hz$$ balanced sources. Both voltage sources $${S_1}$$ and $${S_2}$$ are in phase. The feeder supplies concentrated loads of unity power factor as shown in the figure.
The contributions of $${S_1}$$ and $${S_2}$$ in $$100$$ $$A$$ current supplied at location $$P$$ respectively, are
3
GATE EE 2012
MCQ (Single Correct Answer)
+2
-0.6
For the system shown below, SD1 and SD2 are complex power demands at bus $$1$$ and bus $$2$$ respectively. If $$\left| {{V_2}} \right| = 1$$ pu, the VAR rating of the capacitor (QG2) connected at bus $$2$$ is
4
GATE EE 2011
MCQ (Single Correct Answer)
+2
-0.6
A lossy capacitor $${C_x}$$, rated for operation at $$5$$ $$kV,$$ $$50$$ $$Hz$$ is represented by an equivalent circuit with an ideal capacitor $${C_p}$$ in parallel with a resistor $${R_p}$$. The value $${C_p}$$ is found to be $$0.102$$ $$\mu F$$ and the value of $${R_p}$$ $$=$$ $$1.25$$ $$M\Omega .$$ Then the power loss and $$tan\delta $$ of the lossy capacitor operating at the rated voltage, respectively, are
Questions Asked from Parameters and Performance of Transmission Lines (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE EE 2018 (1)
GATE EE 2017 Set 2 (2)
GATE EE 2017 Set 1 (1)
GATE EE 2016 Set 1 (2)
GATE EE 2015 Set 2 (1)
GATE EE 2014 Set 2 (1)
GATE EE 2014 Set 3 (2)
GATE EE 2014 Set 1 (2)
GATE EE 2012 (1)
GATE EE 2011 (1)
GATE EE 2010 (3)
GATE EE 2009 (1)
GATE EE 2008 (1)
GATE EE 2007 (3)
GATE EE 2006 (1)
GATE EE 2005 (1)
GATE EE 2004 (4)
GATE EE 2003 (4)
GATE EE 2001 (2)
GATE EE 2000 (2)
GATE EE 1999 (4)
GATE EE 1998 (2)
GATE EE 1996 (1)
GATE EE 1995 (1)
GATE EE 1994 (2)
GATE EE Subjects
Electromagnetic Fields
Signals and Systems
Engineering Mathematics
General Aptitude
Power Electronics
Power System Analysis
Analog Electronics
Control Systems
Digital Electronics
Electrical Machines
Electric Circuits