A 1 mm thick cylindrical tube, 100 mm in diameter, is orthogonally turned such that the entire wall thickness of the tube is cut in a single pass. The axial feed of the tool is 1 m/minute and the specific cutting energy (u) of the tube material is 6 J/mm³. Neglect contribution of feed force towards power. The power required to carry out this operation is _________ kW (round off to one decimal place).

Two cutting tools with tool life equations given below are being compared:
$$\eqalign{ & Tool\,\,1:\,\,\,\,\,\,\,V{T^{0.1}} = 150 \cr & Tool\,\,2:\,\,\,\,\,\,\,V{T^{0.3}} = 300 \cr} $$
where $$V$$ is cutting speed in $$m/minute$$ and $$T$$ is tool life in minutes. The breakeven cutting speed beyond which Tool $$2$$ will have a higher tool life is _______________ $$m/minute$$.

In an orthogonal machining with a tool of $${9^ \circ }$$ orthogonal rake angle, the uncut chip thickness is $$0.2$$ $$mm.$$ The chip thickness fluctuates between $$0.25$$ $$mm$$ and $$0.4$$ $$mm.$$ The ratio of the maximum shear angle to the minimum shear angle during machining is ______________

During the turning of a $$20$$ $$mm-$$diameter steel bar at a spindle speed of $$400$$ $$rpm,$$ a tool life of $$20$$ minute is obtained. When the same bar is turned at $$200$$ $$rpm,$$ the tool life becomes $$60$$ $$minute.$$ Assume that Taylor's tool life equation is valid. When the bar is turned at $$300$$ $$rpm,$$ the tool life (in minute) is approximately