A buck converter feeding a variable resistive load is shown in the figure. The switching frequency of the switch $$S$$ is $$100$$ $$kHz$$ and the duty ratio is $$0.6.$$ The output voltage $${V_0}$$ is $$36$$ $$V.$$ Assume that all the components are ideal, and that the output voltage is ripple-free. The value of $$R$$ (in $$Ohm$$) that will make the inductor current ($${{\rm I}_L}$$) just continuous is _______.

The circuit shown is meant to supply a resistive load $${R_L}$$ from two separate $$DC$$ voltage sources. The switches $$S1$$ and $$S2$$ are controlled so that only one of them is ON at any instant. $$S1$$ is turned on for $$0.2$$ $$ms$$ and $$S2$$ is turned on for $$0.3$$ $$ms$$ in a $$0.5$$ $$ms$$ switching cycle time period. Assuming continuous conduction of the inductor current and negligible ripple on the capacitor voltage, the output voltage $${V_0}$$ (in Volt) across $${R_L}$$ is __________.

A self commutating switch $$SW,$$ operated at duty cycle $$\delta $$ is used to control the load voltage as shown in the figure

Under steady state operating conditions, the average voltage across the indicator and the capacitor respectively, are

Figure (i) shows the circuit diagram of a chopper. The switch $$S$$ in the circuit in figure (i) is switched such that the voltage $${V_D}$$ across the diagram as the wave shape as shown in figure (ii). The capacitance $$C$$ is large so that the voltage across it is constant. If switch $$S$$ and the diode are ideal, the peak to peak ripple (in A) in the inductor current is ________.