1
GATE EE 2006
MCQ (Single Correct Answer)
+2
-0.6
A voltage commutated chopper operating at $$1$$ $$kHz$$ is used to control the speed of $$dc$$ motor as shown in figure. The load current is assumed to be constant at $$10$$ $$A.$$
The minimum time in $$\mu $$ sec for which the $$SCR$$ $$M$$ should be ON is
2
GATE EE 2006
MCQ (Single Correct Answer)
+2
-0.6
A voltage commutated chopper operating at $$1$$ $$kHz$$ is used to control the speed of $$dc$$ motor as shown in figure. The load current is assumed to be constant at $$10$$ $$A.$$
The average output voltage of the chopper will be
3
GATE EE 2005
MCQ (Single Correct Answer)
+2
-0.6
The given figure shows a step $$-$$ down chopper switched at $$1$$ $$KHz$$ with a duty ratio $$D = 0.5.$$
The peak - peak ripple in the load current is close to
4
GATE EE 2004
MCQ (Single Correct Answer)
+2
-0.6
Figure shows a chopper. The device $${S_1}$$ is the main switching device. $${S_2}$$ is the auxiliary commutation device. $${S_1}$$ is rated for $$400V, 60A.$$ $${S_2}$$ is rated for $$400V, 30 A.$$ the load current is $$20$$ $$A.$$ The main device operates with a duty ratio of $$0.5.$$ The peak current through $${S_1}$$ is
Questions Asked from Choppers and Commutation Techniques (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE EE 2024 (1)
GATE EE 2023 (1)
GATE EE 2022 (1)
GATE EE 2018 (2)
GATE EE 2017 Set 2 (1)
GATE EE 2017 Set 1 (1)
GATE EE 2015 Set 1 (3)
GATE EE 2015 Set 2 (1)
GATE EE 2014 Set 1 (1)
GATE EE 2013 (2)
GATE EE 2012 (1)
GATE EE 2011 (1)
GATE EE 2010 (2)
GATE EE 2009 (1)
GATE EE 2008 (1)
GATE EE 2007 (1)
GATE EE 2006 (3)
GATE EE 2005 (1)
GATE EE 2004 (2)
GATE EE 2003 (1)
GATE EE 2002 (1)
GATE EE 2000 (1)
GATE EE Subjects
Electric Circuits
Electromagnetic Fields
Signals and Systems
Electrical Machines
Engineering Mathematics
General Aptitude
Power System Analysis
Electrical and Electronics Measurement
Analog Electronics
Control Systems
Power Electronics