The figure shows the single line diagram of a power system with a double circuit transmission line. The expression for electrical power is $$\,1.5\,\,\sin \delta ,\,\,$$ where $$\delta $$ is the rotor angle. The system is operating at the stable equilibrium point with mechanical power equal to $$1$$ pu. If one of the transmission line circuits is removed, the maximum value of $$\delta ,$$ as the rotor swings is $$1.221$$ radian. If the expression for electrical power with one transmission line circuit removed is $$\,{P_{\max }}\,\sin \delta ,\,\,$$ the valueof $${P_{\max }}\,,$$ in pu is _________.

A 50 Hz generating unit has H-constant of 2 MJ/MVA. The machine is initially operating in steady state at synchronous speed, and producing 1 pu of real power. The initial value of the rotor angle $$\delta $$ is $${5^ \circ }$$, when a bolted three phase to ground short circuit fault occurs at the terminal of the generator. Assuming the input mechanical power to remain at 1 pu, the value of $$\delta $$ in degrees, 0.02 second after the fault is _____________

The synchronous generator shown in the figure is supplying active power to an infinite bus via two short, lossless transmission lines, and is initially in steady state. The mechanical power input to the generator and the voltage magnitude E are constant. If one line is tripped at time t₁ by opening the circuit breakers at the two ends (although there is no fault), then it is seen that the generator undergoes a stable transient. Which one of the following waveforms of the rotor angle $$\delta $$ shows the transient correctly?

The figure shows the single line diagram of a single machine infinite bus system.

The inertia constant of the synchronous generator $$𝐻 = 5$$ $$MW-s/MVA.$$ Frequency is $$50Hz.$$ Mechanical power is $$1$$ pu. The system is operating at the stable equilibrium point with rotor angle $$\delta $$ equal to $${30^ \circ }$$. A three phase short circuit fault occurs at a certain location on one of the circuits of the double circuit transmission line. During fault, electrical power in pu is $$\,{P_{\max }}\,\,\sin \delta .\,\,\,$$. If the values of $$\delta $$ and $$d$$$$\delta $$$$/dt$$ at the instant of fault clearing are $${45^ \circ }$$ and $$3.762$$ radian/s respectively, then $$\,{P_{\max }}$$ (in pu) is _________.