1
GATE EE 2014 Set 3
MCQ (Single Correct Answer)
+1
-0.3
For a fully transposed transmission line
2
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+1
-0.3
Three phase to ground fault takes place at locations $${F_1}$$ and $${F_2}$$ in the system shown in the figure.
If the fault takes place at location $${F_1}$$, then the voltage and the current at bus A are $${V_F1}$$ and $${{\rm I}_{F1}}$$ respectively. If the fault takes place at location $${F_2}$$, then the voltage and the current at bus A are $${V_{F2}}$$ and $${{\rm I}_{F2}}$$ respectively.
The correct statement about voltages and currents during faults at $${F_1}$$ and $${F_2}$$ is
3
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+1
-0.3
A 2-bus system and corresponding zero sequence network are shown in the figure.
The transformers T1 and T2 are connected as
A
B
C
D
4
GATE EE 2012
MCQ (Single Correct Answer)
+1
-0.3
The sequence components of the fault current are as follows:
$${{\rm I}_{positive}} = j1.5\,pu,\,\,{{\rm I}_{negative}} = - j0.5\,\,pu,$$
$${{\rm I}_{zero}} = - j1\,\,pu.$$ The typeof fault in the system is
$${{\rm I}_{positive}} = j1.5\,pu,\,\,{{\rm I}_{negative}} = - j0.5\,\,pu,$$
$${{\rm I}_{zero}} = - j1\,\,pu.$$ The typeof fault in the system is
Questions Asked from Symmetrical Components and Symmetrical and Unsymmetrical Faults (Marks 1)
Number in Brackets after Paper Indicates No. of Questions
GATE EE Subjects
Electric Circuits
Electromagnetic Fields
Signals and Systems
Electrical Machines
Engineering Mathematics
General Aptitude
Power System Analysis
Electrical and Electronics Measurement
Analog Electronics
Control Systems
Power Electronics