1
GATE ME 2004
MCQ (Single Correct Answer)
+2
-0.6
A solid circular shaft of $$60$$ mm diameter transmits a torque of $$1600$$ N - m. The value of maximum shear developed is
A
$$37.72$$ MPa
B
$$47.72$$ MPa
C
$$57.72$$ MPa
D
$$67.72$$ MPa
2
GATE ME 2004
MCQ (Single Correct Answer)
+2
-0.6
A torque of $$10$$ $$N-m$$ is transmitted through a stepped shaft as shown in figure. The torsional stiffnesses of individual sections of lengths $$MN, NO$$ and $$OP$$ are $$20$$ $$N-m/rad,$$ $$30$$ $$N-m/rad$$ and $$60$$ $$N-m/rad$$ respectively. The angular deflection between the ends $$M$$ and $$P$$ of the shaft is GATE ME 2004 Strength of Materials - Torsion Question 13 English
A
$$0.5$$ $$rad$$
B
$$1.0$$ $$rad$$
C
$$5.0$$ $$rad$$
D
$$10.0$$ $$rad$$
3
GATE ME 1994
MCQ (Single Correct Answer)
+2
-0.6
Two shafts $$A$$ and $$B$$ are made of the same material. The diameter of shaft $$B$$ is twice that of shaft $$A$$. the ratio of power which can be transmitted by shaft $$A$$ to that of shaft $$B$$ is
A
$${1 \over 2}$$
B
$${1 \over 4}$$
C
$${1 \over 8}$$
D
$${1 \over 16}$$
4
GATE ME 1993
Subjective
+2
-0
A circular rod of diameter $$d$$ and length $$3d$$ is subjected to a compressive force $$F$$ acting at the top point as shown below. Calculate the stress at the bottom-most support point A. GATE ME 1993 Strength of Materials - Torsion Question 16 English
GATE ME Subjects
Turbo Machinery
EXAM MAP