1
GATE ME 1996
MCQ (Single Correct Answer)
+5
-1.5
Tool life of a $$10$$ hours is obtained when cutting with a single point tool at $$63m/min.$$ If Taylor's constant $$C=257.35,$$ tool life on doubling the velocity will be
A
$$5$$ hours
B
$$25.7$$ $$min$$
C
$$38.3$$ $$min$$
D
unchanged
2
GATE ME 1995
Subjective
+5
-0
While turning a $$C15$$ steel of $$160mm$$ diameter at $$215rpm,$$ $$2.5mm$$ depth of cut and feed of $$0.16mm/rev$$ by a tool of geometry $$0-10-8-9-15-75-0mm,$$ the following observations were made. Tangential component of the cutting force $$=500N,$$ axial component of the cutting force $$=200N,$$ chip thickness $$=0.48mm.$$ Determine the dynamic shear strength of the work piece material.
3
GATE ME 1995
Subjective
+5
-0
A single point turning tool is designated as $$${10^ \circ } - {12^ \circ } - {7^ \circ } - {5^ \circ } - {20^ \circ } - {50^ \circ } - {0^ \circ }\left( {ORS} \right)$$$
The values of normal rake and normal clearance of the above mentioned tool .............
4
GATE ME 1995
Subjective
+5
-0
If under a condition of plain turning the life of the cutting tool decreases by $$50\% $$ due to increase in the cutting velocity by $$20\% $$, then what is the $$\% $$ increase in tool life due to reduction in the cutting velocity by $$20%$$ from its original value.
GATE ME Subjects
Turbo Machinery
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12