1
GATE ME 1989
MCQ (Single Correct Answer)
+1
-0.3
The size of $$BLUE$$ in metal cutting increases with
A
very high speed
B
large uncut chip thickness
C
use of cutting fluid
D
increase in positive rake angle
2
GATE ME 1989
MCQ (Single Correct Answer)
+1
-0.3
Crater wear always starts at some distance from the tool tip because at that point
A
cutting fluid does not penetrate
B
chip tool interface temp is maximum
C
normal stress on rake face is maximum
D
tool strength is minimu8m
3
GATE ME 1988
MCQ (Single Correct Answer)
+1
-0.3
The ideal cutting fluid for low speed machining of metals should be one which
A
removes the heat faster from the cutting zone,
B
forms a coating on the cutting tool by chemical reaction
C
forms a low shear strength film of work material at the tool chip interface
D
serves as a dielectric minimizing thereby reactions due to $$EMF$$ at the interface
4
GATE ME 1987
MCQ (Single Correct Answer)
+1
-0.3
If in a turning operation both the feed rate and the nose radius are doubled the surface finish values will be
A
Decreases by $$50\% $$
B
Increases by $$300\% $$
C
Increases by $$100\% $$
D
Remain unaffected
GATE ME Subjects
Turbo Machinery
EXAM MAP