1
GATE ME 2016 Set 1
Numerical
+1
-0
In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and thrust force are $$500$$ $$N$$ and $$250$$ $$N,$$ respectively. The coefficient of friction between the tool and the chip is ________________
Your input ____
2
GATE ME 2015 Set 1
Numerical
+1
-0
Under certain cutting conditions, doubling the cutting speed reduces the tool life to $${\left( {{1 \over {16}}} \right)^{th}}$$ of the original. Taylor’s tool life index $$(n)$$ for this tool workpiece combination will be ______________
Your input ____
3
GATE ME 2014 Set 4
MCQ (Single Correct Answer)
+1
-0.3
Better surface finish is obtained with a large rake angle because
A
the area of shear plane decreases resulting in the decrease in shear force and cutting force
B
the tool becomes thinner and the cutting force is reduced
C
less heat is accumulated in the cutting zone
D
the friction between the chip and the tool is less
4
GATE ME 2014 Set 3
Numerical
+1
-0
A straight turning operation is carried out using a single point cutting tool on an $$AISI$$ $$1020$$ steel rod. The feed is $$0.2$$ $$mm/rev$$ and the depth of cut is $$0.5$$ $$mm.$$ The tool has a side cutting edge angle of $${60^ \circ }.$$ The uncut chip thickness (in $$mm$$) is _______________
Your input ____
GATE ME Subjects
Turbo Machinery
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12