GATE EE 1998 | Logic Families and Memories Question 4 | Digital Electronics

GATE EE 1998

MCQ (Single Correct Answer)

-0.3

In standard $$TTL$$ gates, the totem pole output stage is primarily used to

Increase the noise margin of the gate

Decrease the output switching delay

Facilitate a wired OR logic connection

Increase the output impedance of the circuit

GATE EE 1998

MCQ (Single Correct Answer)

-0.3

The open collector outputs of two$$2$$-inputs $$NAND$$ gates are connected to a common pull up resistor. If the input to the gates are $$P,Q$$ and $$R,S$$ respectively, the output is equal to

$$\overline {PQ} \,.\,\overline {RS} $$

$$\overline {PQ} \,+\,\overline {RS} $$

$$PQ+RS$$

$$PQRS$$

GATE EE Subjects

Electromagnetic Fields

Time Varying Fields Electrostatics Magnetostatics

Signals and Systems

Continuous and Discrete Time Signals Linear Time Invariant Systems Continuous Time Signal Fourier Transform Discrete Time Signal Z Transformation Continuous Time Signal Laplace Transform Sampling Theorem Continuous Time Periodic Signal Fourier Series Miscellaneous

Engineering Mathematics

Calculus Vector Calculus Linear Algebra Differential Equations Probability and Statistics Transform Theory Complex Variable Numerical Methods

General Aptitude

Verbal Ability Logical Reasoning Numerical Ability

Power Electronics

Choppers and Commutation Techniques Single and Three Phase Rectifier Power Semiconductor Devices Ac Voltage Controllers Inverters

Power System Analysis

Per Unit System Power Generation Cost Power System Stability Symmetrical Components and Symmetrical and Unsymmetrical Faults Circuit Breaker Switch Gear and Protection Load Flow Studies High Voltage Dc Transmission Generating Power Station Parameters and Performance of Transmission Lines

Analog Electronics

Diode Circuits and Applications Frequency Response Bjt and Mosfet Biasing 555 Timer Feedback Amplifiers and Oscillator Circuits Operational Amplifier Small Signal Modeling

Control Systems

Block Diagram and Signal Flow Graph Polar Nyquist and Bode Plot State Variable Analysis Basics of Control System Routh Hurwitz Stability Time Response Analysis Root Locus Techniques Controller and Compensator

Digital Electronics

Boolean Algebra Logic Gates Combinational Circuits Minimization Logic Families and Memories Sequential Circuits Analog to Digital and Digital to Analog Converter Microprocessor

Electrical Machines

Induction Machines D.C Machines Synchronous Machines Transformers

Electric Circuits

Network Elements Network Theorems Three Phase Circuits Transient Response Sinusoidal Steady State Analysis Graph Theory Two Port Networks

Electrical and Electronics Measurement

Basic of Indicating Instruments Error Analysis and Measurement Measurement of Resistance and A.C Bridges Measurement of Energy and Power Digital Voltmeters Questions Potentiometer and Instrument Transformers Cathode Ray Oscilloscope