In an orthogonal cutting test on mild steel, the following data were obtained
Cutting speed: $$40$$ $$m/min,$$
Depth of cut: $$0.3$$ $$mm,$$
Tool rake angle : $$ + {5^ \circ },$$
Chip thickness: $$1.5$$ $$mm,$$
Cutting force: $$900$$ $$N,$$
Thrust force: $$450$$ $$N$$
Using Merchant's analysis, the Friction angle during the machining will be

A cylinder is turned on a lathe with orthogonal machining principle. Spindle rotates at $$200rpm$$. The axial feed rate is $$0.25$$ $$mm$$ per revolution. Depth of cut is $$0.4mm.$$ The rake angle is $${10^ \circ }.$$ In the analysis it is found that the shear angle is $${27.75^ \circ },$$

The thickness of the produced chip is

A cylinder is turned on a lathe with orthogonal machining principle. Spindle rotates at $$200rpm$$. The axial feed rate is $$0.25$$ $$mm$$ per revolution. Depth of cut is $$0.4mm.$$ The rake angle is $${10^ \circ }.$$ In the analysis it is found that the shear angle is $${27.75^ \circ },$$

In the above problem, the coefficient of friction at the chip tool interface obtained using Earnest and Merchant theory is

A tube of $$32mm$$ outside diameter was turned on a lathe and the following data was obtained
Rake angle $$=35deg,$$
Feed rate $$=0.1mm/rev$$
Cutting force $$=2000N,$$
Cutting speed $$=15m/min$$
Length of continuous chip is one revolution $$=60mm$$

Feed force $$=800N.$$ Calculate the chip thickness, shear plane angle, velocity of chip along tool face and coefficient of friction.