In a shear cutting operation, a sheet of $$5mm$$ thickness is cut along a length of $$200mm.$$ The cutting blade is $$400mm$$ long and zero-shear $$(S=0)$$ is provided on the edge. The ultimate shear strength of the sheet is $$100$$ $$MPa$$ and penetration to thickness ratio is $$0.2.$$ Neglect friction

A shear of $$20mm$$ $$(S=20mm)$$ is now provided on the blade. Assuming force $$Vs$$ displacement curve to be trapezoidal, the maximum force (in $$kN$$) exerted is

In the deep drawing of cups, blanks show a tendency to wrinkle up around the periphery (flange). The most likely cause and remedy of the phenomenon are respectively,

The force requirement in a blanking operation of low carbon steel sheet is $$5.0$$ $$kN.$$ The thickness of the sheet is $$'t'$$ and diameter of the blanked part is $$'d'.$$ For the same work material, if the diameter of the blanked part is increased to $$1.5d$$ and thickness is reduced to $$0.4t$$, the new blanking force in $$kN$$ is

Match the items in column $${\rm I}$$ and $${\rm I}$$ $${\rm I}$$