1
GATE ME 2006
MCQ (Single Correct Answer)
+2
-0.6
If each abrasive grain is viewed as a cutting tool, then which of the following represents the cutting parameters in common grinding operations?
2
GATE ME 2005
MCQ (Single Correct Answer)
+2
-0.6
A $$600$$ $$mm$$ $$ \times \,\,30\,\,mm$$ flat surface of a plate is to be finish machined on a shaper. The plate has been fixed with the $$600$$ $$mm$$ side along the tool travel direction. If the tool over-travel at each end of the plate is $$20$$ $$mm,$$ average cutting speed is $$8$$ $$m/min,$$ feed rate is $$0.3$$ $$mm/stroke$$ and the ratio of return time to cutting time of the tool is $$1:2,$$ the time required for machining will be
3
GATE ME 2004
MCQ (Single Correct Answer)
+2
-0.6
Through holes of $$10$$ $$mm$$ diameter are to be drilled in steel plate of $$20$$ $$mm$$ thickness. Drill spindle speed is $$300$$ $$rpm,$$ feed $$0.2$$ $$mm/rev$$ and drill point angle is $${120^0}.$$ Assuming drill over travel of $$2mm$$ the time for producing a hole will be
4
GATE ME 2002
MCQ (Single Correct Answer)
+2
-0.6
The time taken to drill a hole though a $$25$$ $$mm$$ thick plate with the drill rotating at $$300$$ $$rpm$$ and moving at a feed rate of $$0.25$$ $$mm$$/revolution is
Questions Asked from Machining (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE ME 2025 (1)
GATE ME 2024 (1)
GATE ME 2017 Set 1 (1)
GATE ME 2015 Set 3 (1)
GATE ME 2014 Set 2 (1)
GATE ME 2012 (1)
GATE ME 2008 (1)
GATE ME 2006 (1)
GATE ME 2005 (1)
GATE ME 2004 (1)
GATE ME 2002 (1)
GATE ME 2000 (1)
GATE ME 1995 (3)
GATE ME 1994 (1)
GATE ME 1993 (1)
GATE ME 1992 (1)
GATE ME 1991 (3)
GATE ME Subjects
Engineering Mechanics
Machine Design
Strength of Materials
Heat Transfer
Production Engineering
Industrial Engineering
Turbo Machinery
Theory of Machines
Engineering Mathematics
Fluid Mechanics
Thermodynamics
General Aptitude