Cylindrical pins of $${25^{\matrix{ { + 0.020} \cr { + 0.010} \cr } }}\,\,mm$$ diameter are electroplated in a shop. Thickness of the plating is $$30 \pm 0.2$$ micron. Neglecting gage tolerances, the size of the $$GO$$ gage in $$mm$$ to inspect the plated components is

A shaft has a dimension $$\phi $$ $${35^{\matrix{ { - 0.009} \cr { - 0.025} \cr } }}$$. The respective values of fundamental deviation and tolerance are

A taper hole is inspected using a $$CMM,$$ with a probe of $$2mm$$ diameter. At a height, $$Z=10mm$$ from the bottom, $$5$$ points are touched and a diameter of circle (not compensated for probe size) is obtained as $$20mm.$$ similarly, a $$40mm$$ diameter is btained at a height $$Z=40mm.$$ The smaller diameter (in $$mm$$) of hole at $$Z=0$$ is

What are the upper and lower limits of the shaft represented by $$60{f_8}$$?

Use the following data:
Diameter $$60$$ lies in the diameter step of $$50-80$$ $$mm$$
Fundamental tolerance unit, $$i,$$ in $$\mu m = 0.45\,\,{D^{1/3}} + 0.001D,$$
where $$D$$ is the representative size in $$mm;$$ Tolerance value for $${\rm I}T8 = 25i,$$ Fundamental deviation for $$'‘f’'$$ shaft $$ = - 5.5{D^{0.41}}$$