The voltage-arc length characteristics of a $$DC$$ arc is given by $$V=20+4L.$$ Where $$L$$ is in $$mm$$. During a welding operation arc length is expected to vary between $$4$$ and $$6$$ $$mm$$ with the welding current limited between $$450$$ and $$550$$amps.

If the power source has a linear characteristic, the open circuit voltage is.

The voltage-arc length characteristics of a $$DC$$ arc is given by $$V=20+4L.$$ Where $$L$$ is in $$mm$$. During a welding operation arc length is expected to vary between $$4$$ and $$6$$ $$mm$$ with the welding current limited between $$450$$ and $$550$$amps.

The arc power at an arc length of $$5mm$$ is

Welding of $$C40$$ steel plate of $$10mm$$ thickness required a current of $$16$$amps, while it was $$360$$amps when the plate thickness was increased by $$50\% $$. Estimate the welding current for $$8mm$$ thickness of same material.

The cross section weld bead is shown in fig the profile of the bead and the fusion zone are taken circular for convenience. Bead width and radii of curvature of circular profiles are given in fig. The bead height and depth of penetration are