1
GATE ME 2025
MCQ (Single Correct Answer)
+2
-0.67
The endurance limit of a specific grade of steel is same as its yield strength. The ultimate strength of this grade of steel is twice of its yield strength. A component made of this steel is loaded in tension and unloaded periodically. It is required that the component does NOT fail for at least $10^6$ loading cycles, as per the Soderberg law. Considering a factor of safety of 2 , the maximum applied tensile principal stress is
2
GATE ME 2017 Set 1
Numerical
+2
-0
A machine element has an ultimate strength $$\left( {{\sigma _u}} \right)$$ of $$600\,\,N/m{m^2},$$ and endurance limit $$250$$ $$\,N/m{m^2}.$$ The fatigue curve for the element on log-log plot is shown below. If the element is to be designed for a finite of $$10000$$ cycles, the maximum amplitude of a completely reversed operating stress is _________ $$\,N/m{m^2}.$$
Your input ____
3
GATE ME 2016 Set 2
MCQ (Single Correct Answer)
+2
-0.6
In a structural member under fatigue loading, the minimum and maximum stresses developed at the critical point are $$50$$ $$MPa$$ and $$150$$ $$MPa,$$ respectively. The endurance, yield, and the ultimate strengths of the material are $$200$$ $$MPa,$$ $$300$$ $$MPa$$ and $$400$$ $$MPa,$$ respectively. The factor of safety using modified Goodman criterion is
4
GATE ME 2013
MCQ (Single Correct Answer)
+2
-0.6
A bar is subjected to fluctuating tensile load from $$20$$ $$kN$$ to $$100$$ $$kN.$$ The material has yield strength of $$240$$ $$MPa$$ and endurance limit in reversed bending is $$160$$ $$MPa.$$ According to the Soderberg principle, the area of cross-section in $$m{m^2}$$ of the bar for a factor of safety of $$2$$ is
Questions Asked from Fatigue Strength (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE ME Subjects
Engineering Mechanics
Strength of Materials
Theory of Machines
Engineering Mathematics
Machine Design
Fluid Mechanics
Turbo Machinery
Heat Transfer
Thermodynamics
Production Engineering
Industrial Engineering
General Aptitude