A single-phase full bridge voltage source inverter (VSI) feeds a purely inductive load. The inverter output voltage is a square wave in 180° conduction mode. The fundamental frequency of the output voltage is 50 Hz. If the DC input voltage of the inverter is 100 V and the value of the load inductance is 20 mH, the peak-to-peak load current in amperes is ________ (rounded off to the nearest integer).

Consider an ideal full-bridge single-phase DC-AC inverter with a DC bus voltage magnitude of 1000 V. The inverter output voltage v(t) shown below, is obtained when diagonal switches of the inverter are switched with 50% duty cycle. The inverter feeds a load with a sinusoidal current given by, $$i(t) = 10\sin \left( {\omega t - {\pi \over 3}} \right)A$$, where $$\omega = {{2\pi } \over T}$$. The active power, in watts, delivered to the load is __________. (round off to nearest integer).

A 3-phase grid-connected voltage source converter with DC link voltage of 1000 V is switched using sinusoidal Pulse Width Modulation (PWM) technique. If the rid phase current is 10 A and the 3-phase complex power supplied by the converter is given by ($$-$$4000 $$-$$ j3000) VA, then the modulation index used in sinusoidal PWM is _________. (round off to two decimal places).

A single-phase full bridge inverter fed by a 325 V DC produces a symmetric quasi-square waveform across " $a b$ " as shown. To achieve a modulation index of 0.8 , the angle $\theta$ expressed in degrees should be $\_\_\_\_$ . (Round off to 2 decimal places)

(Modulation index is defined as the ratio of the peak of the fundamental component of $V_{d b}$ to the applied DC value)