GATE EE 2022 | Inverters Question 5 | Power Electronics

GATE EE 2022

Numerical

-0

A 3-phase grid-connected voltage source converter with DC link voltage of 1000 V is switched using sinusoidal Pulse Width Modulation (PWM) technique. If the rid phase current is 10 A and the 3-phase complex power supplied by the converter is given by ($$-$$4000 $$-$$ j3000) VA, then the modulation index used in sinusoidal PWM is _________. (round off to two decimal places).

Your input ____

GATE EE 2021

Numerical

-0

A single-phase full bridge inverter fed by a 325 V DC produces a symmetric quasi-square waveform across " $a b$ " as shown. To achieve a modulation index of 0.8 , the angle $\theta$ expressed in degrees should be $\_\_\_\_$ . (Round off to 2 decimal places)

GATE EE 2021 Power Electronics - Inverters Question 2 English (Modulation index is defined as the ratio of the peak of the fundamental component of $V_{d b}$ to the applied DC value)

Your input ____

GATE EE 2017 Set 2

MCQ (Single Correct Answer)

-0.6

The figure below shows a half-bridge voltage source inverter supplying an $$RL$$-load with $$R = 40\,\,\Omega $$ and $$L = \left( {{{0.3} \over \pi }} \right)H.$$ The desired fundamental frequency of the load voltage is $$50$$ $$Hz.$$ The switch control signals of the converter are generated using sinusoidal pulse width modulation with modulation index. $$M = 0.6.$$ at $$50$$ $$Hz$$, the$$RL$$-load draws an active power of $$1.44$$ $$kW.$$ The value of $$DC$$ source volts is GATE EE 2017 Set 2 Power Electronics - Inverters Question 9 English

GATE EE 2017 Set 2 Power Electronics - Inverters Question 9 English

$$300\,\,\sqrt 2 $$

$$500$$

$$500\,\,\sqrt 2 $$

$$1000\,\,\sqrt 2 $$

GATE EE 2016 Set 1

Numerical

-0

The switches $$T1$$ and $$T2$$ in Figure are switched in a complementary fashion with sinusoidal pulse width modulation technique. The modulating voltage $${v_m}\left( t \right) = 0.8\sin \left( {200\pi t} \right)\,\,V$$ and the triangular carrier $$\left( {{V_c}} \right),$$ voltage $$\left( {{V_c}} \right)$$ are as shown in figure $$(b).$$ The carrier frequency is $$5$$ $$kHz.$$ The peak value of the $$100$$ $$Hz$$ component of the load current $$\left( {{i_L}} \right)$$ in Ampere, is ______. GATE EE 2016 Set 1 Power Electronics - Inverters Question 10 English 1