1
GATE ME 2011
MCQ (Single Correct Answer)
+1
-0.3
A hole is dimension $$\phi {9^{\matrix{ { + 0.015} \cr { + 0\,\,\,\,\,\,\,\,\,\,} \cr } }}\,mm.$$ The corresponding shaft is of dimension $$\phi {9^{\matrix{ { + 0.010} \cr { + 0.001} \cr } }}\,mm.$$ The resulting assembly has
A
loose running fit
B
close running fit
C
transition fit
D
interference fit
2
GATE ME 2006
MCQ (Single Correct Answer)
+1
-0.3
Ring gage is used to measure
A
outside diameter but not roundness
B
roundness but not outside diameter
C
both outside diameter and roundness
D
only external threads
3
GATE ME 2005
MCQ (Single Correct Answer)
+1
-0.3
In order to have interference fit, it is essential that the lower limit of the shaft should be
A
Greater than the upper limit of the hole
B
Lesser than the upper limit of the hole
C
Greater than the lower limit of the hole
D
Lesser than the lower limit of the hole
4
GATE ME 2001
MCQ (Single Correct Answer)
+1
-0.3
Allowance in limits and fits refers to
A
Maximum clearance between shaft and hole
B
Minimum clearance between shaft and hole
C
Difference between maximum and minimum size of hole
D
Difference between maximum and minimum size of shaft
GATE ME Subjects
Turbo Machinery
EXAM MAP