GATE ECE 2000
GATE ECE
Introducing a resistor in the emitter of a common amplifier, stabilizes the dc operating point against variations in
View Question In the circuit shown in the figure assume that the transistor is in
the active region. It has a large β and its base Emi
View Question For the amplifier of given figure,$${I_C}\, = \,1.3\,mA,\,{R_C}\, = \,2\,k\Omega ,\,{R_E}\, = \,500\,\Omega ,$$ $${V_T}
View Question The current gain of a bipolar transistor drops at high frequencies because of
View Question In the circuit of figure V0 is
View Question If the Op-Amp in the figure, is ideal, than V0 is
View Question The most commonly used Amplifier in sample and hold circuit is
View Question If the Op-Amp in the figure has an input offset voltage of 5 mV and an open-loop voltage gain of 10,000, V0 will be
View Question In a digital communication system employing Frequency Shift Keying (FSK), the 0 and 1 bit are represented by sine waves
View Question In an FM system, a carrier of 100 MHz is modulated by a sinusoidal signal of 5
KHz. The bandwidth by Carson’s approximat
View Question For the linear, time-invariant system whose block diagram is shown in Fig.
with input x(t) and output y(t),
(a) Find t
View Question A linear time invariant system has an impulse response e2t, t > 0. If the initial
conditions are zero and the input i
View Question An amplifier with resistive negative feedback has two left half-plane poles in its
open-loop transfer function. The ampl
View Question The block diagram of a feedback system is shown in Figure.
(a) Find the closed loop transfer function.
(b) Find the mi
View Question A system described by the transfer function
$$$H\left(s\right)=\frac1{s^3+\alpha s^2+ks+3}$$$ is stable. The constraints
View Question A certain linear, time-invariant system has the state and output representation shown below:
$$$\eqalign{
& \left[
View Question In the figure, the J and K inputs of all the four Flip-Flops are made high. The frequency of the signal at output Y is
View Question The number of comparators in 4-bit flash ADC is
View Question For the 4 bit DAC shown in Figure, the output voltage $${V_0}$$ is
View Question A sequential circuit using D flip-flop and logic gates is shown in the figure, where X and Y are the inputs and Z is the
View Question For the logic circuit shown in Figure, the required input condition (A, B, C) to make the output (X)=1.
View Question For the logic circuit shown in the figure, the simplified Boolean expression for the output Y is
View Question The operating conditions (ON = 1, OFF = 0) of three pumps (x,y,z) are to be
monitored. x = 1 implies that pump X is on.
View Question A TEM wave is incident normally upon a perfect conductor. The E and H fields at the boundary will be respectively
View Question The magnitudes of the open-circuit and short-circuit input impedances of a transmission line are 100$$\Omega \,$$ and 25
View Question A uniform plane wave in air impinges at 45° angle on a lossless dielectric material with dielectric constant $${\varepsi
View Question The three regions shown in Fig. are all lossless and non-magnetic. Find
(a) Wave impedance in mediums 2 and 3.
(b) d
View Question A rectangular waveguide has dimensions $$1\,\,cm\,\, \times \,\,0.5\,\,cm$$. Its cut-off frequency is
View Question For an 8 feet (2.4 m) parabolic disk antenna operating at 4 GHz, the minimum distance required for far field measurement
View Question The half-power beam widths (HPBW) of an antenna in the two orthogonal planes are $${100^ \circ }$$ and $${60^ \circ }$$
View Question If the diameter of a $$\lambda /2$$ dipole antenna is increased from $$\lambda /100$$ to $$\lambda /50$$ then is
View Question The eigen values of the matrix $$\left[ {\matrix{
2 & { - 1} & 0 & 0 \cr
0 & 3 & 0 & 0
View Question $$\int\limits_0^{{\raise0.5ex\hbox{$\scriptstyle \pi $}
\kern-0.1em/\kern-0.15em
\lower0.25ex\hbox{$\scriptstyle 2$}}} {
View Question If $$\,\,\,$$ $$L\left\{ {f\left( t \right)} \right\} = {{s + 2} \over {{s^2} + 1}},\,\,L\left\{ {g\left( t \right)} \r
View Question In the 8085 microprocessor, the RST6 instruction transfers the program
execution to the following location
View Question The number of hardware interrupts (which require an external signal to interrupt)
present in an 8085 microprocessor are
View Question The network $$N$$ in Fig. consists only of two elements: a resistor of $$1\Omega $$ and an inductor of L Henry. $$A$$ $$
View Question In Fig., the steady state output voltage corresponding to the input voltage $$\left( {3 + 4\sin \,\,100\,t} \right)$$ $$
View Question For the circuit in Fig. Which is in steady state,
(a)Find the frequency $${\omega _0}$$ at which the magnitude of the
View Question In the circuit of Fig., the value of the voltage source E is
View Question For the circuit in Fig. the voltage V0 is
View Question Use the data of Fig.(a). The current i in the circuit of Fig.(b) is
View Question The circuit of Fig. represents a
View Question For the circuit in Fig., write the state equations using vc
and iL as state variables.
View Question For the circuit in Fig.
(a) Find the Thevenin equivalent of the sub circuit faced by the capacitor across
the terminals
View Question In the circuit of Fig., the votage v(t) is
View Question Given that $$L\left[ {f\left( t \right)} \right]\, = \,$$ $${{s + 2} \over {{s^2} + 1}},$$
$$$L\left[ {g\left( t \right
View Question A system with an input x(t) and an output y(t) is described by the relation: y(t) = t x(t). This system is
View Question The Fourier Transform of the signal $$x(t) = {e^{ - 3{t^2}}}$$ is of the following form, where A
and B are constants:
View Question A linear time invariant system has an impulse response $${e^{2t}},\,\,t\, > \,0.$$ If the initial conditions are zero
View Question Let u(t) be the unit step function. Which of the waveforms in Fig.(a) -(d) corresponds to the convolution of $$\left[ {u
View Question The Hilbert transform of $$\left[ {\cos \,{\omega _1}t + \,\sin {\omega _2}t\,} \right]$$ is
View Question For the linear, time-invariant system whose block diagram is shown in Fig.(a),
with input x(t) and output y(t).
(a) Find
View Question A system has a phase response given by $$\phi \,(\omega )$$ where $$\omega $$ is the angular frequency. The phase delay
View Question A band limited signal x(t) with a spectrum X(f) as shown in Fig. a is processed as shown in Fig.b. p(t) is a periodic tr
View Question