1
GATE EE 2015 Set 1
Numerical
+1
-0
In the following chopper, the duty ratio of switch $$S$$ is $$0.4.$$ If the inductor and capacitor are sufficiently large to ensure continuous inductor current and ripple free capacitor voltage, the charging current (in Ampere) of the $$5$$ $$V$$ battery, under steady-state, is_____ GATE EE 2015 Set 1 Power Electronics - Choppers and Commutation Techniques Question 37 English
Your input ____
2
GATE EE 2014 Set 2
Numerical
+1
-0
A step-up chopper is used to feed a load at $$400$$ $$V$$ $$dc$$ from a $$250$$ $$V$$ $$dc$$ source. The inductor current is continuous. If the ‘off’ time of the switch is $$20\,\,\mu s,$$ the switching frequency of the chopper in $$kHz$$ is ________.
Your input ____
3
GATE EE 2010
MCQ (Single Correct Answer)
+1
-0.3
The power electronic converter shown in the figure has a single-pole double-throw switch. The pole $$P$$ of the switch is connected alternately to throws $$A$$ and $$B.$$ The converter shown is a GATE EE 2010 Power Electronics - Choppers and Commutation Techniques Question 39 English
A
step-down chopper (buck converter)
B
half-wave rectifier
C
step-up chopper (boost converter)
D
full-wave rectifier
4
GATE EE 2002
MCQ (Single Correct Answer)
+1
-0.3
A step down chopper is operated in the continuous conduction mode in steady state with a constant duty ratio $$D.$$ If $${V_0}$$ is the magnitude of the $$dc$$ output voltage and if $${V_s}$$ is the magnitude of the $$dc$$ input voltage, the ratio $${{{V_0}} \over {{V_s}}}$$ is given by
A
$$D$$
B
$$1-D$$
C
$${1 \over {1 - D}}$$
D
$${D \over {1 - D}}$$
GATE EE Subjects
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12