A single-phase transformer has a turns ratio of 1:2, and is connected to a purely resistive load as shown in the figure. The magnetizing current drawn is 1 A, and the secondary current is 1 A. If core losses and leakage reactances are neglected, the primary current is

The single phase, $$50$$ $$Hz$$ iron core transformer in the circuit has both the vertical arms of cross sectional area $$20\,\,c{m^2}$$ and both the horizontal arms of cross sectional area $$10\,\,c{m^2}$$. If the two windings shown were wound instead on opposite horizontal arms, the mutual inductances will

It is desired to measure parameters of $$230$$ $$V/115$$ $$V,$$ $$2$$ $$kVA$$, single-phase transformers. The following watt-meters are available in a laboratory:
$${W_1}:250\,\,V,\,\,\,10\,\,A,\,\,\,\,\,\,$$ Low Power Factor
$${W_2}:250\,\,V,\,\,\,5\,\,A,\,\,\,\,\,\,$$ Low Power Factor
$${W_3}:150\,\,V,\,\,\,10\,\,A,\,\,\,\,\,\,$$ High Power Factor
$${W_4}:150\,\,V,\,\,\,5\,\,A,\,\,\,\,\,\,$$ High Power Factor

The watt-meters used in open circuit test and short circuit test of the transformer will respectively be

In a transformer, zero voltage regulation at full load is