1
GATE CSE 2016 Set 2
MCQ (Single Correct Answer)
+1
-0.3
In an Ethernet local area network, which one of the following statements is TRUE?
A
A station stops to sense the channel once it starts transmitting a frame.
B
The purpose of the jamming signal is to pad the frames that are smaller than the minimum frame size.
C
A station continues to transmit the packet even after the collision is detected.
D
The exponential backoff mechanism reduces the probability of collision on retransmissions.
2
GATE CSE 2015 Set 3
MCQ (Single Correct Answer)
+1
-0.3
Consider a CSMA/CD network that transmits data at a rate of 100 Mbps (108 bits second) over a 1 km(kilometer) cable with no repeaters. If the minimum frame size required for this network is 1250 bytes, what is the signal speed (km/sec) in the cable?
A
8000
B
10000
C
16000
D
20000
3
GATE CSE 2014 Set 2
Numerical
+1
-0
In the diagram shown below, L1 is an Ethernet LAN and L2 is a Token-Ring LAN. An IP packet originates from sender S and traverses to R, as shown. The links within each ISP and across the two ISPs, are all point-to-point’ optical links. The initial value of the TTL field is 32. The maximum possible value of the TTL field when R receives the datagram is ____________. GATE CSE 2014 Set 2 Computer Networks - Lan Technologies and Wi-Fi Question 16 English
Your input ____
4
GATE CSE 2007
MCQ (Single Correct Answer)
+1
-0.3
In Ethernet when Manchester encoding is used, the bit rate is:
A
Half the baud rate.
B
Twice the baud rate.
C
Same as the baud rate.
D
None of the above
GATE CSE Subjects
Software Engineering
Web Technologies
EXAM MAP