1
GATE ECE 2015 Set 1
Numerical
+2
-0
In the system shown in figure (a), m(t) is a low-pass signal with bandwidth W Hz. The frequency response of the band-pass filter H(f) is shown in figure (b). If it is desired that the output signal z(t) = 10x(t), the maximum value of W (in Hz) should be strictly less than ____________________. GATE ECE 2015 Set 1 Communications - Analog Communication Systems Question 4 English
Your input ____
2
GATE ECE 2015 Set 1
MCQ (Single Correct Answer)
+2
-0.6
A sinusoidal signal of 2 kHz frequency is applied to a delta modulator. The sampling rate and step-size $$\Delta $$ of the delta modulator are 20,000 samples per second and 0.1 V, respectively. To prevent slope overload, the maximum amplitude of the sinusoidal signal (in Volts) is
A
$${1 \over {2\pi }}$$
B
$${1 \over \pi }$$
C
$${2 \over \pi }$$
D
$$\pi $$
3
GATE ECE 2015 Set 1
Numerical
+2
-0
The transmitted signal in a GSM system is of 200 kHz bandwidth and 8 users share a common bandwidth using TDMA. If at a given time 12 users are talking in a cell, the total bandwidth of the signal received by the base station of the cell will be at least (in kHz) ___________________.
Your input ____
4
GATE ECE 2015 Set 1
Numerical
+2
-0
The input X to the Binary Symmetric Channel (BSC) shown in the figure is ‘1’ with probability 0.8. The cross-over probability is 1/7. If the received bit Y = 0, the conditional probability that ‘1’ was transmitted is _______. GATE ECE 2015 Set 1 Communications - Noise In Digital Communication Question 13 English
Your input ____
EXAM MAP
Medical
NEET
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
CBSE
Class 12