1
GATE EE 2011
MCQ (Single Correct Answer)
+1
-0.3
A dual trace oscilloscope is set to operate in the ALTernate. The control input of the multiplexer used in the y-circuit is fed with a signal having a frequency equal to
A
the highest frequency that the multiplexer can operate properly
B
twice the frequency of the time base (sweep) oscillator
C
the frequency of the time base (sweep) oscillator
D
half the frequency of the time base (sweep) oscillator
2
GATE EE 2011
MCQ (Single Correct Answer)
+1
-0.3
The bridge circuit shown in the fig below is used for the measurement of an unknown element Zx. The bridge circuit is best suited when Zx is a GATE EE 2011 Electrical and Electronics Measurement - Measurement of Resistance and A.C Bridges Question 15 English
A
Low resistance
B
High resistance
C
Low Q Inductor
D
Lossy Capacitor.
3
GATE EE 2011
MCQ (Single Correct Answer)
+2
-0.6
The direct axis and quadrature axis reactances of a salient pole alternator are $$1.2$$ $$p.u$$ and $$1.0$$ $$p.u$$ respectively. The armature resistance is negligible. If this alternator is delivering rated $$kVA$$ at $$upf$$ and at rated voltage then its power angle is
A
$${30^ \circ }$$
B
$${45^ \circ }$$
C
$${60^ \circ }$$
D
$${90^ \circ }$$
4
GATE EE 2011
MCQ (Single Correct Answer)
+1
-0.3
A three-phase, salient pole synchronous motor is connected to an infinite bus. It is operated at no load a normal excitation. The field excitation of the motor is first reduced to zero and then increased in reverse direction gradually. Then the armature current
A
Increases continuously
B
First increases and then decreases steeply
C
First decreases and then increases steeply
D
Remains constant