1
GATE CE 2002
Subjective
+5
-0
Calculate the shape factor for the $$T$$-section shown in the following figure made up of two plates $$100\,\,mm \times 10\,\,mm.$$ What will be the load factor if the permissible stress in bending is only $$2/3$$ of the yield stress $$\left( {{\sigma _y}} \right)$$

2
GATE CE 1998
Subjective
+5
-0
The steel portal frame shown in figure is subjected to an imposed service load of $$15$$ $$kN$$. Compute the required plastic moment capacity of the members. All the members are of the same cross-section. Draw the collapse load.

Questions Asked from Plastic Analysis (Marks 5)
Number in Brackets after Paper Indicates No. of Questions
GATE CE Subjects
Construction Material and Management
Geomatics Engineering Or Surveying
Engineering Mechanics
Transportation Engineering
Strength of Materials Or Solid Mechanics
Reinforced Cement Concrete
Steel Structures
Environmental Engineering
Engineering Mathematics
Structural Analysis
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
General Aptitude