Eccentric Connections · Steel Structures · GATE CE

Rivets and bolts subjected to both shear stress $$\left( {{\tau _{vf}},\,cal} \right)$$ and axial tensile stress $$\left( {{\sigma _{tf,cal}}} \right)$$ shall be so proportioned that the stresses do not exceed the respective allowable stresses $${\tau _{vf,}}$$ and $${{\sigma _{tf,}}}$$ and the value of $$\left( {{{{\tau _{vf.cal}}} \over {{\tau _{vf}}}} + {{{\sigma _{tf,cal}}} \over {{\sigma _{tf}}}}} \right)$$ does not exceed

A column is subjected to a load through a bracket as shown in figure

The resultant force (in $$kN,$$ up to one decimal place) in the bolt $$1$$ is _______________

A bracket plate connected to a column flange transmits a load of $$100$$ $$kN$$ as shown in the following figure. The maximum force for which the bolts should be designed is _______ $$kN$$

The tension and shear force (both in $$kN$$) in each bolt of the joint, as shown below, respectively are

A bracket connection is made with four bolts of $$10$$ $$mm$$ diameter and supports a load of $$10$$ $$kN$$ a an eccentricity of $$100$$ $$mm.$$ The maximum force to be resisted by any bolt will be

A moment $$M$$ of magnitude $$50$$ $$kN$$-$$m$$ is transmitted to a column flange through a bracket by using four $$20$$ $$mm$$ diameter rivets as shown in the figure. The shear force induced in the rivet $$A$$ is

A $$12$$ $$mm$$ bracket plate is connected to a column flange as shown in the figure below. The bracket transmits a load of $$W = 200\,\,kN$$ to the column flange. $$A$$ $$10$$ $$mm$$ fillet weld is provided along $$AB,$$ $$BC$$ and $$CD.$$ If $$e=350$$ $$mm,$$ $$b=200$$ $$mm$$ and $$d=600$$ $$mm,$$ Verify if the size of the weld provided is adequate. Allowable shearing stress in the fillet weld can be taken to be $$108$$ $$MPa.$$