Stability and Static Indeterminacy · Structural Analysis · GATE CE
Marks 1
1
Consider the following three structures :
Structure I : Beam with hinge support at A, roller at C, guided roller at E, and internal hinges at B and D
Structure II : Pin-jointed truss, with hinge support at A, and rollers at B and D
Structure III : Pin-jointed truss, with hinge support at A and roller at C
Which of the following statements is/are TRUE?
GATE CE 2023 Set 1
2
Consider a beam PQ fixed at P, hinged at Q, and subjected to a load F as shown in figure (not drawn to scale). The static and kinematic degrees of indeterminacy, respectively are
GATE CE 2022 Set 2
3
The degree of static indeterminacy of a rigid jointed frame PQR supported as shown in the figure is
GATE CE 2014 Set 1
4
The static indeterminacy of the two-span continuous beam with an internal hinge, shown
below, is ______________.
GATE CE 2014 Set 2
5
A beam fixed at the ends and subjected to lateral loads only is statically indeterminate and the degree of indeterminacy is
GATE CE 1994
6
The plane frame shown a side is
GATE CE 1988
Marks 2
1
A planar truss tower structure is shown in the figure:
Consider the following statements about the external and internal determinacies of the truss.
(P) Externally Determinate
(Q) External Static Indeterminacy = 1
(R) External Static Indeterminacy = 2
(S) Internally Determinate
(T) Internal Static Indeterminacy = 1
(U) Internal Static Indeterminacy = 2
Which one of the following options is correct?
Consider the following statements about the external and internal determinacies of the truss.(P) Externally Determinate
(Q) External Static Indeterminacy = 1
(R) External Static Indeterminacy = 2
(S) Internally Determinate
(T) Internal Static Indeterminacy = 1
(U) Internal Static Indeterminacy = 2
Which one of the following options is correct?
GATE CE 2017 Set 1
2
The degree of static indeterminacy of a rigidly jointed frame in a horizontal plane
and subjected to vertical loads only, as shown in figure below is
GATE CE 2009
3
The degree of static indeterminacy of the rigid frame having two internal hinges
as shown in the figure below, is
GATE CE 2008
4
The plane figure shown below is
GATE CE 1993
5
The plane structure shown below is
GATE CE 1992
6
A plane frame $$ABCDEFGH$$ shown in figure below has clamp supports at A and axial force release (horizontal sleeve) at $$'C'$$ and moment release (hinge) at $$E.$$ The static indeterminacy of the frame is
GATE CE 1992
7
The static Indeterminacy of the structure shown below is
GATE CE 1990
8
The static Indeterminacy of the structure shown below is
GATE CE 1989
9
Member $$'AB'$$ of the truss shown below has a lack of fit of $$1$$ $$mm.$$ $$B$$ if $$E = 2 \times {10^5}\,\,MPa,$$ area of $$c/s$$ $$ = 20\,\,m{m^2}.$$ The force in $$'AB'$$ is __________
GATE CE 1988
10
The static Indeterminacy of the structure shown below is
GATE CE 1987