A hole is specified as $${40^{\matrix{ {0.050} \cr {0.000} \cr } }}\,\,mm.$$ The mating shaft has a clearance fit with minimum clearance of $$0.01mm.$$ The tolerance on the shaft is $$0.04mm.$$ The maximum clearance in $$mm$$ between the hole and the shaft is

The force requirement in a blanking operation of low carbon steel sheet is $$5.0$$ $$kN.$$ The thickness of the sheet is $$'t'$$ and diameter of the blanked part is $$'d'.$$ For the same work material, if the diameter of the blanked part is increased to $$1.5d$$ and thickness is reduced to $$0.4t$$, the new blanking force in $$kN$$ is

In orthogonal turning of medium carbon steel, the specific machining energy is $$2$$ $$kJ/m{m^3},$$ the cutting velocity, feed and depth of cut are $$120m/min,$$ $$0.2mm/rev$$ and $$2mm$$ respectively. The main cutting force $$N$$ is

A low carbon steel bar of $$147$$ $$mm$$ diameter with length of $$630$$ $$mm$$ is being turned with uncoated carbide insert. The observed tool lives are $$24$$ and $$12$$ for cutting velocities of $$90$$ $$m/min$$ and $$120$$ $$m/min$$ respectively. The feed and depth of cut are $$0.2$$ $$mm/rev$$ and $$2$$ $$mm$$ respectively. Use the unmachined diameter to calculate the cutting velocity.

Neglect over travel or approach of the tool. When tool life is $$20min,$$ the machining time in $$min$$ for a single pass is