1
GATE CE 2003
MCQ (Single Correct Answer)
+2
-0.6
A beams $$PQRS$$ is $$18$$ $$m$$ long and is simply supported at points $$Q$$ and $$R$$ $$10$$ $$m$$ apart. overhangs $$PQ$$ and $$RS$$ are $$3$$ $$m$$ and $$5$$ $$m$$ respectively. A train of two point loads of $$150$$ $$kN$$ and $$100$$ $$kN$$, $$5$$ $$m$$ apart, crosses this beam from left to right with $$100$$ $$kN$$ load leading.
During the passage of the loads, the maximum and the minimum reactions at supports $$'R'$$ in $$kN,$$ are respectively
2
GATE CE 2003
MCQ (Single Correct Answer)
+2
-0.6
A beams $$PQRS$$ is $$18$$ $$m$$ long and is simply supported at points $$Q$$ and $$R$$ $$10$$ $$m$$ apart. overhangs $$PQ$$ and $$RS$$ are $$3$$ $$m$$ and $$5$$ $$m$$ respectively. A train of two point loads of $$150$$ $$kN$$ and $$100$$ $$kN$$, $$5$$ $$m$$ apart, crosses this beam from left to right with $$100$$ $$kN$$ load leading.
The maximum sagging moment under the $$150$$ $$kN$$ load anywhere is
3
GATE CE 2003
MCQ (Single Correct Answer)
+2
-0.6
A beams $$PQRS$$ is $$18$$ $$m$$ long and is simply supported at points $$Q$$ and $$R$$ $$10$$ $$m$$ apart. overhangs $$PQ$$ and $$RS$$ are $$3$$ $$m$$ and $$5$$ $$m$$ respectively. A train of two point loads of $$150$$ $$kN$$ and $$100$$ $$kN$$, $$5$$ $$m$$ apart, crosses this beam from left to right with $$100$$ $$kN$$ load leading.
The maximum hogging moment in the beam anywhere is
4
GATE CE 2001
MCQ (Single Correct Answer)
+2
-0.6
Identify, from the following, the correct value of the bending moment $${M_A}\,\,$$ (in $$kNm$$ units) at the fixed end $$A$$ in the statically determinate beam shown below (with internal hinges at $$B$$ and $$D),$$ when a uniformly distributed load of $$10$$ $$kN/m$$ is placed on the spans. (Hint: Sketching the influence line for $${M_A}\,\,$$ or applying the Principle of Virtual Displacements makes the solution easy).
Questions Asked from Influence Line Diagram (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE CE Subjects
Construction Material and Management
Geomatics Engineering Or Surveying
Engineering Mechanics
Transportation Engineering
Strength of Materials Or Solid Mechanics
Reinforced Cement Concrete
Steel Structures
Environmental Engineering
Engineering Mathematics
Structural Analysis
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
General Aptitude