1
GATE CE 2015 Set 2
MCQ (Single Correct Answer)
+1
-0.3
A steel member ‘M’ has reversal of stress due to live loads, whereas another member ‘N’ has reversal of stress due to wind load. As per $$IS$$ $$800: 2007,$$ the maximum slenderness ratio permitted is:
$$\left( 1 \right)\,\,\,\,\,$$ Lesser for member $$‘M’$$ than that of member $$‘N’$$
$$\left( 2 \right)\,\,\,\,\,$$ More for member $$‘M’$$ than for member $$‘N’$$
$$\left( 3 \right)\,\,\,\,\,$$ Same for both the members
$$\left( 4 \right)\,\,\,\,\,$$ Not specified in the Code
$$\left( 1 \right)\,\,\,\,\,$$ Lesser for member $$‘M’$$ than that of member $$‘N’$$
$$\left( 2 \right)\,\,\,\,\,$$ More for member $$‘M’$$ than for member $$‘N’$$
$$\left( 3 \right)\,\,\,\,\,$$ Same for both the members
$$\left( 4 \right)\,\,\,\,\,$$ Not specified in the Code
2
GATE CE 2006
MCQ (Single Correct Answer)
+1
-0.3
In the design of welded tension members, consider the following statements:
$${\rm I}.\,\,\,\,\,\,\,\,\,$$ The entire cross-sectional area of the connected leg is assumed to contribute to the effective area in case of angles.
$${\rm II}.\,\,\,\,\,\,\,\,\,$$ Two angles back-to-back and tack-welded as per code requirements may be assumed to be behave as a $$T$$-section
$${\rm III}.\,\,\,\,\,\,\,\,\,$$ A check on slenderness ratio may be necessary in some cases.
The TRUE statements are
3
GATE CE 2005
MCQ (Single Correct Answer)
+1
-0.3
The permissible stress in axial tension in steel member on the net effective area of the section shall not exceed the following value ($${{f_y}}$$ is the yield stress)
Questions Asked from Tension Members (Marks 1)
Number in Brackets after Paper Indicates No. of Questions
GATE CE Subjects
Construction Material and Management
Geomatics Engineering Or Surveying
Engineering Mechanics
Transportation Engineering
Strength of Materials Or Solid Mechanics
Reinforced Cement Concrete
Steel Structures
Environmental Engineering
Engineering Mathematics
Structural Analysis
Geotechnical Engineering
Fluid Mechanics and Hydraulic Machines
General Aptitude