A capacitive voltage divider is used to measure the bus voltage V_bus in a high-voltage 50Hz AC system as shown in the figure. The measurement capacitors C₁ and C₂ have tolerances of $$ \pm $$10% on their nominal capacitance values. If the bus voltage V_bus is 100 kV rms, the maximum rms output voltage V_out (in kV), considering the capacitor tolerances, is __________.

Match the following.

A 3-phase balanced load which has a power factor of 0.707 is connected to a balanced supply. The power consumed by the load is 5 kW. The power is measured by the two-wattmeter method. The readings of the two wattmeters are

The coils of a wattmeter have resistances $$0.01$$ $$\Omega $$ and $$1000$$ $$\Omega $$; their inductances may be neglected. The wattmeter is connected as shown in the figure, to measure the power consumed by a load, which draws $$25$$ $$A$$ at power factor $$0.8$$. The voltage across the load terminals is $$30$$ $$V$$. The percentage error on the wattmeter reading is______________.