A solid circular shaft needs to be designed to transmit a torque of $$50$$ $$N.m.$$ If the allowable shear stress of the material is $$140$$ $$MPa,$$ assuming a factor of safety of $$2,$$ the minimum allowable design diameter in $$mm$$ is

A solid cylinder of diameter $$100$$ $$mm$$ and height $$50$$ $$mm$$ is forged between two frictionless flat dies to a height of $$25$$ $$mm.$$ The percentage change in diameter is

In a single pass rolling process using $$410mm$$ diameter steel rollers, a strip of width $$140mm$$ and thickness $$8mm$$ undergoes $$10\% $$ reduction of thickness. The angle of bite in radians is

In a $$DC$$ $$arc$$ welding operating, the length characteristic was obtained as $${V_{arc}} = 20 + 5l$$ where the $$arc$$ length $$l$$ was varied between $$5mm$$ and $$7mm.$$ Here $${V_{arc}}$$ denotes the arc voltage in volts. The $$arc$$ current was varied from $$400A$$ to $$500A.$$ Assuming linear power source characteristic, the open circuit voltage and the short circuit current for the welding operation are