1
GATE EE 2010
MCQ (Single Correct Answer)
+1
-0.3
A wattmeter is connected as shown in the fig. the wattmeter reads GATE EE 2010 Electrical and Electronics Measurement - Measurement of Energy and Power Question 23 English
A
zero always
B
Total power consumed by $${Z_1}$$ & $${Z_2}$$
C
Power consumed by $${Z_1}$$
D
Power consumed by $${Z_2}$$
2
GATE EE 2010
MCQ (Single Correct Answer)
+2
-0.6
A $$50$$ $$Hz$$ synchronous generator is initially connected to a long lossless transmission line which is open circuited at the receiving end. With the field voltage held constant, the generator is disconnected from the transmission line. Which of the following may be said about the steady state terminal voltage and field current of the generator?
A
The magnitude of terminal voltages decreases, and the field current does not change.
B
The magnitude of terminal voltage increases, and the field current dose not change.
C
The magnitude of terminal voltages decreases, and the field current increases.
D
The magnitude of terminal voltage does not change, and the field current decreases.
3
GATE EE 2010
MCQ (Single Correct Answer)
+2
-0.6
A separately excited $$dc$$ machine is coupled to a $$50Hz,$$ three-phase, 4-pole induction machine as shown in the figure. The dc machine is energized first and the machines rotate at $$1600$$ $$rpm.$$ Subsequently the induction machine is also connected to a $$50Hz,$$ three-phase source, the phase sequence being consistent with the direction of rotation. In steady state GATE EE 2010 Electrical Machines - Synchronous Machines Question 27 English
A
both machine act as generators
B
the $$dc$$ machine acts as a generator, and the induction machine acts as a motor
C
the $$dc$$ machine acts as a motor, and the induction machine acts as a generator
D
both machines act as motors
4
GATE EE 2010
MCQ (Single Correct Answer)
+2
-0.6
A separately excited DC motor runs at 1500 rpm under no-load with 200 V applied to the armature. The field voltage is maintained at its rated value. The speed of the motor, when it delivers a torque of 5 Nm, is 1400 rpm as shown in the figure. The rotational losses and armature reaction are neglected. GATE EE 2010 Electrical Machines - D.C Machines Question 40 English For the motor to deliver a torque of 2.5 Nm at 1400 rpm the armature voltage to be applied is
A
125.5 V
B
193.3 V
C
200 V
D
241.7 V
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12