A cylinder is turned on a lathe with orthogonal machining principle. Spindle rotates at $$200rpm$$. The axial feed rate is $$0.25$$ $$mm$$ per revolution. Depth of cut is $$0.4mm.$$ The rake angle is $${10^ \circ }.$$ In the analysis it is found that the shear angle is $${27.75^ \circ },$$

The thickness of the produced chip is

A batch of $$10$$ cutting tools could produce $$500$$ components while working at $$50$$ $$rpm$$ with a tool feed of $$0.25$$ $$mm/rev$$ and depth of cut of $$1$$ $$mm.$$ A similar batch of $$10$$ tools of the same specification could produce $$122$$ components while working at $$80$$ $$rpm$$ with a feed of $$0.25$$ $$mm/rev$$ and $$1$$ $$mm$$ depth of cut. How many components can be produced with one cutting tool at $$60$$ $$rpm$$?

Formation on build-up edge during machining can be avoided by using

The arc - voltage characteristics of a $$DC$$ power source has a linear power source characteristic of $$V=20+40L,$$ where $$V$$ is the arc voltage in volts and $$L$$ is the arc length in $$cm.$$ The static volt-ampere characteristic of the power source is approximated by a straight line with open circuit voltage $$=80V$$ and short circuit current is $$600Amps,$$ determine the optimum arc length for maximum power