1
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+1
-0.3
In an oscilloscope screen, linear sweep is applied at the
A
Vertical axis
B
Horizontal axis
C
Origin
D
Both horizontal and vertical axis
2
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+1
-0.3
Power consumed by a balanced $$3$$-phase, $$3$$-wire load is measured by the two wattmeter method. The first wattmeter reads twice that of the second. Then the load impedance angle in radians is
A
$${\pi \over 2}$$
B
$${\pi \over 8}$$
C
$${\pi \over 6}$$
D
$${\pi \over 3}$$
3
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+2
-0.6
A three phase synchronous generator is to be connected to the infinite bus. The lamps are connected as shown in the figure for the synchronization. The phase sequence of bus voltage is $$R$$-$$Y$$-$$B$$ and that of incoming generator voltage is $$R'$$ - $$Y'$$ - $$B'.$$ GATE EE 2014 Set 1 Electrical Machines - Synchronous Machines Question 30 English

It was found that the lamps are becoming dark in the sequence $${L_a} - {L_b} - {L_c}.$$ It means that the phase sequence of incoming generator is

A
opposite to infinite bus and its frequency is more than infinite bus
B
opposite to infinite bus but its frequency is less than infinite bus
C
same as infinite bus and its frequency is more than infinite bus
D
same as infinite bus and its frequency is less than infinite bus
4
GATE EE 2014 Set 1
MCQ (Single Correct Answer)
+2
-0.6
The core loss of a single phase, 230/115 V, 50 Hz power transformer is measured from 230 V side by feeding the primary (230 V side) from a variable voltage variable frequency source while keeping the secondary open circuited. The core loss is measured to be 1050 W for 230 V, 50 Hz input. The core loss is again measured to be 500W for 138 V, 30 Hz input. The hysteresis and eddy current losses of the transformer for 230 V, 50 Hz input are respectively.
A
508 W and 542 W
B
468 W and 582 W
C
498 W and 552 W
D
488 W and 562 W