GATE ME 2001 | GATE ME Year Wise Previous Years Questions

PREVIOUS NEXT

GATE ME 2001

MCQ (Single Correct Answer)

-0.3

The cutting force in punching and blanking operations mainly depends on

The modulus of elasticity of metal

The shear strength of metal

The bulk modulus of metal

The yield strength of metal

GATE ME 2001

MCQ (Single Correct Answer)

-0.3

Allowance in limits and fits refers to

Maximum clearance between shaft and hole

Minimum clearance between shaft and hole

Difference between maximum and minimum size of hole

Difference between maximum and minimum size of shaft

GATE ME 2001

MCQ (Single Correct Answer)

-0.6

The sun gear in the figure is driven clockwise at 100 rpm. The ring gear is held stationary. For the number of teeth shown on the gears, the arm rotations at GATE ME 2001 Theory of Machines - Gears and Gear Trains Question 21 English

GATE ME 2001 Theory of Machines - Gears and Gear Trains Question 21 English

0 rpm

20 rpm

33.33 rpm

66.67 rpm

GATE ME 2001

MCQ (Single Correct Answer)

-0.3

Which of the following statement is correct?

Flywheel reduces speed fluctuations during a cycle for a constant load, but flywheel does not control the mean speed of the engine if the load changes.

Flywheel does not reduce speed fluctuations during a cycle for a constant load, but flywheel does control the mean speed of the engine if the load changes

Governor control a speed fluctuations during a cycle for a constant load, but governor does not control the mean speed of the engine if the load changes.

Governor controls speed fluctuations during a cycle for a constant load, and governor also controls the mean speed of the engine if the load changes.

PREVIOUS NEXT

GATE ME Papers

2024