The thickness of the blank needed to produce, by power spinning a missile cone of thickness $$1.5mm$$ and half cone angle $$30deg$$

Component process

In horizontal milling process ............................ (up/down) milling provides better surface finish and .............................. Up/down ) milling provide longer tool life.

In an orthogonal cutting operation on a work piece of width $$2.5mm,$$ the uncut chip thickness was $$0.25$$ $$mm$$ and the tool rake angle was $$0$$(zero) degrees. It was observed that the chip thickness was $$1.25mm.$$ The cutting force was measured to be $$900N$$ and the thrust force was found to be $$450N.$$ Find the mean shear strength of the work piece material and if the coefficient of friction between the chip and the tool was $$0.5,$$ what is the machining constant.