Generally cylindrical parts produced by powder metallurgy should not have non uniform cross section and a length to diameter ratio exceeding . . . . . . . . . . . . . . .

A single point cutting tool made of $$HSS$$ has the value of constant $$'C'$$ $$80,$$ and $$n=0.2$$ in the basic tool life equation. If the tool cost per regrind is Rs $$2$$ and the vmachine hour rate is Rs. $$30,$$ determine the most economical cutting speed (tool cost includes the cost of time spent on changing.

A mild steel block of width $$40$$ $$mm$$ is being milled using a straight slab cutter $$70mm$$ diameter with $$30$$teeth. If the cutter rotates at $$40$$$$rpm$$ and the depth of cut is $$2mm,$$ determine the value of maximum uncut chip thickness when the table feed is $$20mm/min$$

To get good surface finish on a turned job, one should use a sharp tool with a ......... Feed rate and ............... Speed of rotation of the job.