In a shaft with a transverse hole, as the hole to the shaft diameter ratio ___________ (increases / decreases), the torsional stress concentration factor__________ (increases/decreases)

When there is no room temp change, the total shrinkage allowance on a pattern is INDEPENDENT OF

Numerically controlled machine tools are better suited for .................. (batch/mass) production, because their setup time is ......... (larger / smaller) in comparison to special purpose machine tools.

A bush was turned after mounting the same on a mandrel. The mandrel diameter in millimeters is $${40^{\matrix{ { + 0.00} \cr { - 0.05} \cr } }}$$ and bore diameter of bush is $${40^{\matrix{ { + 0.06} \cr { - 0.00} \cr } }}$$.

The maximum eccentricity of the bush, in $$mm$$ will be