The parameters which determines the friction factor for turbulent flow in a rough pipe are:

A $$0.20$$ $$m$$ diameter pipe $$20$$ $$km$$ long transport oil at a flow rate of $$0.01{m^3}/s.$$ Calculate the power r

The discharge in $${m^3}/s$$ for laminar flow through a pipe of diameter $$0.04$$ $$m$$ having a centre line velocity of

Water flows through a pipe of diameter $$0.30$$ $$m.$$ What would be the velocity $$V$$ for the conditions shown in the

A circular plate $$1$$ $$m$$ in diameter is submerged vertically in water such that its upper edge is $$8m$$ below the f

A Newtonian fluid has the following velocity field : $$$\overrightarrow V = {x^2}y\widehat i + 2x{y^2}z\widehat j - y{

Steam is flowing through an insulated steel pipe shown in the fig, is losing heat to the surroundings. The details are a

A shell and tube heat exchanger is to be designed for heating pressurized water by means of hot gasses which get cooled

For a glass plate transitivity and reflectivity are specified as $$0.86$$ and $$0.08$$ respectively, the absorptivity of

For the fluid flowing over a flat plate with Prandtle number greater than unity, the thermal boundary layer for laminar

If the load on a ball bearing is reduced to half, the life of the ball bearing will

For full depth of involute spur gears, minimum number of teeth of pinion to avoid interference depends upon

In the design of shafts made of ductile materials subjected to twisting moment and bending moment, the recommended theor

In an engineering drawing one finds the designation of $$20G7F8.$$ The position of tolerance of the hole is indicated by

Cutting speed in grinding is set to a high value to

The standard specification of a grinding wheel is $$A-46-M-6-V-21.$$ It means a wheel of

In twist drills ......... (small/large) point angle and ........ (small/large) helix angle are provided for drilling sof

Pure metal pose machinability problem in turning operations. The reason is the

The ideal cutting fluid for low speed machining of metals should be one which

The contraction allowance provided on the pattern and core boxes compensates for the following type of contraction.

A tapered cantilever beam of constant thickness is loaded as shown in the sketch below. The bending stress will be:

If the length of a column is doubled, the critical load becomes: