A weld is used for joining an angle section ISA 100 mm $$\times$$ 100 mm $$\times$$ 10 mm to a gusset plate of thickness 15 mm to transmit a tensile load. The permissible stress in the angle is 150 MPa and the permissible shear stress on the section through the throat of the fillet weld is 108 MPa. The location of the centroid of the angle is represented by C_yy in the figure, where C_yy = 28.4 mm. The area of cross-section of the angle is 1903 mm². Assuming the effective throat thickness of the weld to be 0.7 times the given weld size, the lengths L₁ and L₂ (rounded off to the nearest integer) of the weld required to transmit a load equal to the full strength of the tension member are, respectively

The hoop stress at a point on the surface of a thin cylindrical pressure vessel is computed to be 30.0 MPa. The value of maximum shear stress at this point is

Consider the cross-section of a beam made up of thin uniform elements having thickness t(t << a) shown in the figure. The (x, y) coordinates of the points along the center-line of the cross-section are given in the figure.

The coordinates of the shear center of this cross-section are :

Consider a simply supported beam PQ as shown in the figure. A truck having 100 kN on the front axle and 200 kN on the rear axle, moves from left to right. The spacing between the axles is 3 m. The maximum bending moment at point R is _________ kNm. (in integer)