Assuming concrete below the neutral axis to be cracked, the shear stress across the depth of a singly-reinforced rectangular beam section

In the design of beams for the limit state of collapse in flexure as per $$IS:$$ $$456$$ - $$2000,$$ let the maximum strain in concrete be limited to $$0.0025$$ (in place of $$0.0035$$). For this situation, consider a rectangular beam section with breadth as $$250$$ $$mm,$$ effective depth as $$350$$ $$mm,$$ area of tension steel as $$1500\,\,m{m^2},$$ and characteristic strengths of concrete and steel as $$30$$ $$MPa$$ and $$250$$ $$MPa$$ respectively.

At the limiting state of collapse in flexure, the force acting on the compression zone of the section is

In the design of beams for the limit state of collapse in flexure as per $$IS:$$ $$456$$ - $$2000,$$ let the maximum strain in concrete be limited to $$0.0025$$ (in place of $$0.0035$$). For this situation, consider a rectangular beam section with breadth as $$250$$ $$mm,$$ effective depth as $$350$$ $$mm,$$ area of tension steel as $$1500\,\,m{m^2},$$ and characteristic strengths of concrete and steel as $$30$$ $$MPa$$ and $$250$$ $$MPa$$ respectively.

The depth of neutral axis for the balanced failure is

Consider the following statements:

$$1.\,\,\,\,\,\,$$ The width-to-thickness ratio limitations on the plate elements under
$$\,\,\,\,\,\,\,\,\,\,\,$$ compression in steel members are imposed by $$IS:$$ $$800$$ - $$1984$$ in order to avoid
$$\,\,\,\,\,\,\,\,\,\,\,$$ fabrication difficulties.
$$2.\,\,\,\,\,\,$$ In a doubly reinforced concrete beam, the strain in compressive reinforcement is
$$\,\,\,\,\,\,\,\,\,\,\,$$ higher than the strain in the adjoining concrete.
$$3.\,\,\,\,\,\,$$ If a cantilever $${\rm I}$$-section supports slab construction all along its length with
$$\,\,\,\,\,\,\,\,\,\,\,$$ sufficient friction between them, the permissible bending stress in compression
$$\,\,\,\,\,\,\,\,\,\,\,$$ will be the same as that in tension.

The TRUE statements are