1
GATE PI 2005
MCQ (Single Correct Answer)
+2
-0.6
A batch of $$500$$ jobs of diameter $$50$$ $$mm$$ and length $$100$$ $$mm$$ is to be turned at $$200$$ $$rev/min$$ and feed $$0.2$$ $$mm/rev.$$

Applying Taylor's equation $$V{T^{0.25}} = 160,$$ the tool life in minutes is

A
$$20.36$$
B
$$22.43$$
C
$$674$$
D
$$28.20$$
2
GATE PI 2005
MCQ (Single Correct Answer)
+2
-0.6
A $$\phi $$ $$40$$ $$mm$$ job is subjected to orthogonal turning by a $$ + {10^ \circ }$$ rake angle tool at $$500$$ $$rev/min.$$ By direct measurement during the cutting operation, the shear angle was found equal to $${25^ \circ }.$$

If the friction angle at the tool-chip interface is $${58^ \circ }$$ $$10'$$ and the cutting force components measured by a dynamometer are $$600$$ $$N$$ and $$200$$ $$N$$, the power loss due to friction (in $$kNm/min$$) is approximately

A
$$20$$
B
$$18$$
C
$$16$$
D
$$350$$
3
GATE PI 2005
MCQ (Single Correct Answer)
+2
-0.6
A $$\phi $$ $$40$$ $$mm$$ job is subjected to orthogonal turning by a $$ + {10^ \circ }$$ rake angle tool at $$500$$ $$rev/min.$$ By direct measurement during the cutting operation, the shear angle was found equal to $${25^ \circ }.$$

The velocity (in $$m/min$$) with which the chip flows on the tool face is

A
$$32$$
B
$$63$$
C
$$22$$
D
$$27.5$$
4
GATE PI 2005
MCQ (Single Correct Answer)
+2
-0.6
The following data relate to an orthogonal turning process:
$$\,\,\,\,\,\,\,\,\,\,\,$$Back rake angle $$=15deg,$$
$$\,\,\,\,\,\,\,\,\,\,\,$$Width of cut $$=2mm,$$
$$\,\,\,\,\,\,\,\,\,\,\,$$Chip thickness $$=0.4mm,$$
$$\,\,\,\,\,\,\,\,\,\,\,$$Feed rate $$=0.2mm/rev.$$

The shear angle is

A
$${14^ \circ }$$
B
$${25^ \circ }$$
C
$${29^ \circ }$$
D
$${75^ \circ }$$
EXAM MAP
Medical
NEET
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
CBSE
Class 12