A $$\phi \,\,25$$ $$mm$$ hole is pierced in a $$t=2.5mm$$ thick steel sheet having shear strength $$\tau = 350\,\,MPa.$$ If the diametral clearance is given by the expression $$C=0.0064$$ $$t$$ $$\sqrt \tau ,$$ the die diameter (in $$mm$$), punch diameter (in $$mm$$) and punch force in $$(kN)$$ respectively are

Cold shut (lap) may occur in products obtained by:

Flash and gutter are provided in drop forging dies at the following stage:

A level having $${90^0}$$ bend is to be produced by drop forging using mild steel bar as raw material. The various operations to be performed on it during forging are:
$$P$$ - Cutting;
$$Q$$ - Bending;
$$R$$ - Fullering;
$$S$$ - Blocking cum finishing;
$$T$$ - Edgering

The correct sequence for performing the operations is: